Technical Data (PT9c-1)
Pressure ratio 39:1
Max. free-flow output 35.0lpm (9.25gpm)
Air inlet pressure 3-6bar (44-87psi)
Air consumption 100-1000lpm (26.4-264gpm)
Diameter of air cylinder 250mm (9.84in.)
Dimensions 520580960mm (1.71.93.15ft)
G.W./N.W. 85/70kg
Pump Type Pneumatic piston pump
Ideal Uses
Steel structures, C-shaped section steel, Boats and ships
Storage tanks, Bridges, Water locks
Floor on ground, Railway vehicles
Automobiles ,Trailers,
Containers, Pipelines,
Spray
Primers, High-viscosity epoxy zinc-rich coatings
High-viscosity inorganic zinc coatings, Lacquers
Oil-based paints, Enamels, Water-based paints
Refractory paints, Other paints
Advantages Environmentally friendly thanks to noise levels being kept to a minimum by the optimized control system and the large built in muffler.
Efficient use through the simultaneous operation of multiple spray guns, depending on the nozzle size used.
Generously sized air ducts and a new control system guarantee a rapid changeover of the air motor, practically eliminating any pulsation of the spray jet and the freezing of the air motor.
Filter system prevents downtime.
Above average service life due to hard chromed dual pistons, carbide faced valve plates and stainless steel valve balls.
Self-adjusting packings reduce wear and tear and lower maintenance costs.
Large valve and material passages make processing highly viscous materials simple.
A closed lubrication chamber separates the air motor and the material pump. The lubricant prevents fluids from drying onto the piston rod and protects the packings.
Maintenance free, low noise compressed air engine. Self- adjusting packings. Dual action pump with a long stroke
