New LED Welcome Light Specifications: 1. Power Supply:DC 12V+/-10% 2. Power Cable Length: 2.5Meters Further: 1.whorl design,best heat dissipation effect 2.Aluminium alloy casing,shake proof,high temperature and corrosion resistance 3.Grinding process is applied to improve the texture of the product 4.Plane mirror,waterproof,dustproof Attention: 1.We strongly suggest installing this product by Professional Automobile Modify Factory or Workshop. The manufacturers disclaim all responsibility for belongings or personal casualty caused by improper installation or misuse. 2.Our company does not responsible for the legality of installing this product,please confirm with the vehicle management department for the record before installation ; It is better not to keep the product working more than 60 minutes to avoid damaging its lifespan; 3.Please access the positive and negative poles of the power through voltage regulator rectifier. Do NOT direct access to car battery. What is door light? The Courtesy door light is specially designed for auto modification fancier; we purpose to bring more driving fun to drivers; The dazzle logo light will display on the ground when you open the car door ,and will turn off when you close the door; It can be installed in both left and right door.Courtesy door light make your car artistic moreover the atmosphere. Embedded type design will not destroy the original car appearance. Applicable models: BMW,Honda, Mazda, Toyota, Lexus,Nissan, Kia, Hyundai, Volkswagen,Buick, Ford, Jeep, Porsche, Lamborghini, Ferrari, unlimited,HKS, ABT, IIIM, Harman,AMG, JP, GARSON, FOX, King Kong and so on. About 100models for your choose,Customer's logo is available. How to Install into the car? This product should be installed at the bottom of the door flame and make sure the Len vertical with the ground ; Pull down the inside door board first. Mark the suitable location for drilling a hole. Drill the hole on the door board with our borer . Inset the product from the bottom of car door ,then arrange the power cord. Install the nut through the power cord upon the hole inside; Tighten the nut; Connect the power cord according to the installation guide; Adjust the lamp projection to the suitable place with wrench tool. Reinstall the inside door board,then check the final effect.
